To Next PageTo Next Page
Need help?Do you have a question about the Santon R25 and is the answer not in the manual?
Emphasizes the need for a strong supporting structure for the heater, referring to Table 1.
Specifies the required clearance above the heater for float valve access according to Water Regulations.
Dictates that the heater base must be level with or higher than the highest draw-off point.
Details regulatory requirements for installing servicing valves on inlet and outlet pipes.
Guides on fitting the float valve, including seating selection for different inlet pressures.
Details connecting heater outlet, mains water supply, and overflow pipework.
Covers earthing, supply requirements, fuse, switch, and cable specifications.
Emphasizes the need for a strong supporting structure for the heater, referring to Table 1.
Specifies the required clearance above the heater for float valve access according to Water Regulations.
Dictates that the heater base must be level with or higher than the highest draw-off point.
Details regulatory requirements for installing servicing valves on inlet and outlet pipes.
Guides on fitting the float valve, including seating selection for different inlet pressures.
Details connecting heater outlet, mains water supply, and overflow pipework.
Covers earthing, supply requirements, fuse, switch, and cable specifications.
General| Voltage | 230 V |
|---|---|
| Energy class | C |
| Capacity | 25 liters |
| Mounting | Vertical |
| Maximum operating pressure | 0.8 MPa |
