−29−
To ensure that the meter is used safely, Be sure to observe
the instruction when using the instrument.
1. Never use meter on the electric circuit that exceed 6kVA.
2. Pay special attention when measuring the voltage of AC
30Vrms (42.4 Vpeak) or DC 60V or more to avoid injury.
3. Never apply an input signals exceeding the maximum rating
input value.
4. Never use meter for measuring the line connected with
equipment (i.e.motors) that generates induced or surge
voltage since it may exceed the maximum allowable voltage.
【1】
SAFETY PRECAUTIONS : Before use, read the following safety precautions
This instruction manual explains how to use your multimeter
CD731, 751 safely. Before use, please read this manual thoroughly.
After reading it, keep it together with the product for reference to it
when necessary.
The instruction given under the heading "●WARNING" "●CAUTION"
must be followed to prevent accidental burn or electrical shock.
1-1 Explanation of Warning Symbols
The meaning of the symbols used in this manual and attached to
the product is as follows.
：Very important instruction for safe use.
・The warning messages are intended to prevent accidents to
operating personnel such as burn and electrical shock.
・The caution messages are intended to prevent damage to
the instrument.
：DC ：Glaund
〜：AC ＋：Plus
Ω：Resistance −：Minus
：Continuity ：Fuse
：Diode ：Double insulation
1-2 Warning Instruction for safe use
WARNING
To Next Page
Loading...
