Sanwa CD731 - MEASUREMENT PROCEDURE; Start-up Inspection

−35−
No problem.
Start measurement.
④Short the red and
black test pins.
③Set the function
switch at ●.
①
Connect the test
lead of black plug to
the COM terminal.
【5】MEASUREMENT PROCEDURE
5-1 Start-up Inspection
1. Never use meter if the meter or test leads are damaged or
broken.
2. Make sure that the test leads are not cut or otherwise damaged.
WARNING
②Connect the test
lead of red plug to
the ● terminal.
START
Main unit and
test leads
damaged?
Display shows
00.0〜01.0?
Damaged
No damage
No
Yes
▼
▼
▼
▼
▼
▼
▼
▼
Stop using it and
have it repaired.
Check continuity of
test leads.
▼
▼
▼
①
②
③
④
Fig4