Sanwa CD731 - Storage

−45−
〈How to replace the fuse〉
Fuse of the Specified Rating and Type
0.5A/250V φ5.2×20mm Blowout capacity:300A
20A/250V φ6.3×32mm Blowout capacity:1000A Ceramic
①Remove the holster from the meter.
②Opening the stand of the meter reverse side and remove the
screw with a screwdriver.
③Pull out the fuse out of holder on the circuit board and replace it.
④Put back the rearcase where it was and tighten the screw.
⑤Check and see whether or not indications of respective ranges
are normal.
6-4 Storage
1. The panel and the case are not resistant to volatile solvent and
must not be cleaned with thinner or alcohol.
For cleaning, use dry, soft cloth and wipe it lightly.
2. The panel and the case are not resistant to heat. Do not place the
instrument near heat-generating devices (such as a soldering iron) .
3. Do not store the instrument in a place where it may be subjected
to vibration or from where it may fall.
4. For storing the instrument, avoid hot, cold or humid places or
places under direct sunlight or where condensation is anticipated.
CAUTION
Fig17
Screw
20A/250V
Fuse
0.5A/250VFuse
＋
−
Battery（R6,1.5V×2）
※Thereisainside
ofrearcase.
Following the above instructions, store the instrument in good
environment.