EasyManua.ls Logo

Sanyo Big PACi 18 Series - Page 242

Sanyo Big PACi 18 Series
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6-9
6
6
Setting mode 2
<Operating procedure>
(1) Press and hold the
button, button, and button simultaneously for
4 seconds or longer.
(2) Use the temperature setting
and buttons to change the item
code. The item codes and setting data are shown in the table below.
(3) Use the timer time
and buttons to change the setting data.
To confirm the changed setting data, press the
button.
(At this time, “Setting” stops blinking and remains lit.)
(4) During this mode, “Setting” is displayed, blinking. The display shows the set
outdoor unit address “System XX-YY” (System XX = System address, YY =
Address at outdoor unit sub-bus), item code number (DN value in the table
below), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig.
A
) and the last 3
digits (Fig.
B
). When the first 3 digits are displayed, the top point of the colon is lit.)
(5) To end the setting mode, press the
button. The display returns to the normal display mode.
(3)(1)
(2)
(5)
80: <Refrigerant type>
A
and B are displayed alternately. (Example shows 000 410 (R410A).)
Display of first 3 digits Display of last 3 digits
A
B
(3)
(1)
(2)
(5)
List of Item Codes
Item code Parameter
80 Refigerant typer 407 = R407C 22 = R22 410 = R410A
81 Outdoor unit capacity* 0 = Disabled 22 25 28 32 36 40 45 50 56 63 71 80
90 100 112 125 140 160 180 200 224 250 280 340
355 400 450 500 560 600 630 670 710 800 840
82 Control system schedule Do not set
83 Control system schedule Do not set
84 3-phase or single-phase 0 = 3-phase 1 = single-phase
0 = Disabled 1 = 50Hz85 Power frequency
86 Control system schedule Do not set
87 Control system schedule Do not set
88 Control system schedule Do not set
89 Control system schedule Do not set
8A Control system schedule Do not set
8b Control system schedule Do not set
8E Control temp. for outdoor
fan's crack prevention
Upward fan
model only
available
Setting temperature range : -125
Crack prevention of outdoor fan actuates when the outdoor temp.
reaches lower than the setting values.
~ +125
(*) Figures represent the capacity data for each model.
SM830161Book.indb9SM830161Book.indb9 2008/05/279:33:202008/05/279:33:20

Table of Contents

Related product manuals