MENU OPERATION (TV/ AV mode)
The setting for sound system is only active in TV mode.
Press POINT ŻŹ buttons repeatedly to select "D/K", "I", "M" or "B/G" until the best sound effect is
reached.
This feature is used to remove unwanted channels from the channel scanning memory.
You can skip the unused or undesired channels when you are selecting a channel using POINT Ÿź but-
tons.
This function is only active in TV mode.
The settings for sound system, colour system or skip are automatically memorized in the programme
position.
To swap the channels between two stored programme positions.
Press MENU button to display the main menu.
SOUND SYSTEM
COLOUR SYSTEM
The setting for colour system is only active in TV or AV mode.
Usually, the colour system is set to the position of "AUTO". In case of abnormal colour, repeatedly press
POINT ŻŹ buttons to select "AUTO", "PAL", "SECAM", "NTSC" or "NTSC4.43" until the best colour effect
is reached.
SKIP
CHANNEL SWAP
POINT ŻŹ buttons to select "CHANNEL", and will display
CHANNEL menu. Press POINT Ÿź buttons to select
CHANNEL SWAP.
Press POINT ŻŹ buttons to enter into the Channel Swap
menu. Press POINT Ÿź buttons to select the CHANNEL or
TARGET CHANNEL, then Press POINT ŻŹ buttons to set
the swap channel. And then press POINT Ÿź buttons to
select SWAPPING item, then press POINT ŻŹ buttons to
select "OK".
1
2
3
Ŷ Press BACK button to return to the previous menu.
Ŷ Press MENU button or wait for 5~60 seconds (refer to
"DURATION" on page 29) to exit menu operation.
LCD-CA9S-A NEW.indd 25 2/06/2008 2:08:26 PM
To Next Page
Loading...
Need help?
General
