Sanyo MCO-5M - Performance Specification

3
Performance specification
Model MCO-5M
Usable environment
condition
Temperature: 5㷄䌾35㷄
Humidity: equal or less than 80%R.H.
(When an ambient temperature is equal or lower than 䋫15㷄,
the desired performance may not be obtained)
Temperature control range
Ambient temperature䋫5㷄䌾50㷄
(ambient temperature; 5㷄䌾35㷄)
Temperature distribution
㫧0.25㷄㩷 㶎
(ambient temperature:25㷄, setting:37㷄, CO
2
:5%, no load)
Temperature variation
㫧0.1㷄㩷 㶎
(ambient temperature:25㷄, setting:37㷄, CO
2
:5%, no load)
CO
2
control range
0䌾20䋦
CO
2
variation
㫧0.15䋦
O
2
controller PID control system
O
2
control range
1䌾18䋦, 22䌾80%
O
2
variation
㫧0.2䋦
Chamber humidity
95㫧5䋦RH
CO
2
inlet pressure 0.03 MPaG (0.3kgf/cm
2
G, 4.3psiG)
O
2
inlet pressure 0.05 MPaG (0.5kgf/cm
2
G, 7.1psiG)
Power supply Single phase, local voltage
Maximum power
consumption
205 W
Total maximum current
110-120VAC, 60Hz: Maximum 1.8 A
220-240VAC, 50Hz: Maximum 0.9 A
Maximum heat emission 740 kJ/h
Test condition䋺
Set point䋺䋫37㷄
CO
2
set point䋺5.0䋦
O
2
set point: 5.0%
No load
Ambient temperature䋺䋫25㷄
Ambient humidity䋺Approx.45䋦
㶎 Based on the measuring method on validation service manual.