Sanyo MCO-5M - Control Panel and Keypad

69
13
INCUBATOR COMPONENTS
Control panel and keypad
1. Digital temperature indicator (TEMPERATURE
o
C): Normally, this indicator shows the chamber
temperature. In the setting mode, it shows the set value of the chamber temperature. If the self
diagnostic function detects any abnormality, an error code will be displayed.
2. Heater lamp (HEAT): This lamp lights when the heater is energized.
3. UV indicator (UV): This lamp lights when the UV lamp is ON. The blink of this indicator
recommends the replacement of UV lamp. See page 23 for the details.
4. Door lamp (DOOR): This lamp lights when the outer door is open.
5. Water level alarm lamp (RH PAN): This lamp flashes when the water in the humidifying pan is less
than approximately 0.8 liter.
6. Upper limit regulator: This regulator is used to set the upper temperature limit.
7. Over heat lamp (OVER HEAT): This lamp lights when the chamber temperature reaches the upper
limit set value.
8. CO
2
inject lamp (INJECT): This lamp lights when CO
2
gas is being injected.
9. Digital CO
2
density indicator (CO
2
%): Normally, this indicator shows the CO
2
concentration in the
chamber. In the setting mode, it indicates the set value of the CO
2
concentration. The empty gas
supply line is displayed when CO
2
gas cylinder becomes empty (only when MCO-5GC is installed). See
page 25 for details.
10. O
2
inject lamp (INJECT): This lamp lights when N
2
or O
2
gas is being injected.
11. Digital O
2
density indicator (O
2
%): Normally, this indicator shows the O
2
concentration in the
chamber. In the setting mode, it indicates the set value of the CO
2
concentration. The empty gas
supply line is displayed when N
2
or O
2
gas cylinder becomes empty (only when MCO-5GC is installed).
See page 25 for details.
1
4
5
7
2 3
6
8 9 10 11