90
34
ROUTINE MAINTENANCE
8. To remove the rear duct, lift it up as shown in Fig. 7.
9. To removing the circulating fan, pull out the spring and then pull the fan. See Fig. 8.
10. Replace all attachments in the chamber with the reversed order mentioned above.
Note:
• Always insert the fan on the motor shaft surely.
Check that the fan does not hit the rear panel by
turning the fan manually. Improper insertion may
cause poor performance.
• As shown in the figure, set the shelf with the edge
bent upward. Improper setting may cause a tilted or
unstable condition.
Fig. 7
Fig. 8
Upward bend
To Next Page
Loading...
