Sanyo MDF-U730

DEFROSTING
The defrosting is performed automatically, when a sum of the operation time up to 6 hours.
The defrost water accumulates in the tray evaporates into atmosphere.
Pressing the DEF key for more than 5 seconds, defrost will be started.
And after finishing defrost, freezer will start operating again automatically.
MAINTENANCE
Z\WARNING
Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in
order to prevent electric shock or injury.
Ensure you do not inhale or consume medication or aerosols from around the unit at the time of
maintenance. These may be harmful to your health.
Cleaning
« Clean the unit once a month. Regular cleaning keeps the unit looking new.
* Use a dry cloth to wipe off small amounts of dirt on the outside and inside of the unit and all accessories.
If the outside panels are dirty, clean them with a diluted neutral dishwashing detergent. (Undiluted
detergent can damage the plastic components. For the dilution, refer to the instruction of the detergent.)
After the cleaning with the diluted detergent, always wipe it off with a wet cloth. Then wipe off the cabinet
or accessories with a dry cloth.
+ Never pour water onto or into the unit. Doing so can damage the electrical insulation and may cause
electric shock or short circuit.
* The compressor and other mechanical part are completely sealed. This unit requires absolutely no
lubrication.
-26-