*In the Standard Mode, the messages of the Warning Mode are
informed also by voice guide.
Press the cycle selector
button.
[Example of Liquid Sterilization]
Press the set./confirm.
button.
Press the start button.
Operation is completed.
Warning Mode
• Points to be confirmed and checked when the safety device worked
to stop the operation of the product will be guided in voice.
[Example of Liquid Sterilization]
When opening the cover
In E5 (Heating without
water)only
In CH checking
The liquid sterilization cycle is now in
operation.
Set the sterilization temperature.
The liquid sterilization operation will start.
The liquid sterilization operation has been
completed.
When the cover is closed
Was the amount of heating water checked?
Open the cover, paying attention to steam.
The safety device worked. Check the amount
of heating water.
Now is the time for checking.
Display II
3
2
1
Sound Volume
High
Middle
High
Mode
Standard Mode
Warning Mode
The voice guide of the product is nothing but an auxiliary function.
For safe use this function, please read the precautions and
instructions for use in this manual.
The voice guide of this product can be set to either
S Standard Mode T or S Warning Mode T.
The voice guide has been set at
S
Standard Mode
T
at the time of shipment.
Standard Mode
• For safe use of the product, precautions and operating instructions
are informed in voice.
To change the voice guide settings
1) Press the button for longer than 2 sec. while pressing the
button in standby status.
appears on the digital display I.
appears on the digital display II.
The is the message that is used only for setting the
optional printer.
2)
P
ress the button.
appears on the digital display I.
appears on the digital display II.
3) Press the and buttons to change the figure on the
digital display II.
4) Press the
button for setting.
Voice guide starts in set mode.
The product starts with
the cover being open.
The cover is not closed.
To Next Page
Loading...
Need help?
General
