Product
Soak soft cloth with water or neutral detergent, squeeze the cloth
well and wipe off dirt.
(Standard frequency of cleaning: Once a month)
Do not use thinner, benzene, etc. that may give damage to the
product.
Exhaust tank/Exhaust tank at rear side
If the inside of the exhaust tank becomes dirty, pour hot water
mixed with neutral detergent into the tank and shake it well to
remove dirt, and rinse it thoroughly with water.
(Standard frequency of cleaning: Once a month)
Cover packings and chamber opening
Wipe them carefully with soft cloth impregnated water.
Contaminated cover packings and chamber opening may cause
steam leakage.
(Standard frequency of cleaning: Once a month)
Chamber inside
• Chamber inside
⋅ Wipe the chamber inside with soft cloth impregnated water or
neutral detergent. If it is difficult to get the dirt out of the
chamber, wipe it well with nylon scrubber impregnated with
neutral detergent and then rinse it with running water.
⋅ In the case of liquid sterilization, wash away the dirty liquid with
water when it is boiling over.
(Standard frequency of cleaning: Once a month)
• Bottom of chamber inside
⋅ Remove the heater cover and wash the bottom carefully by
means of a hand brush paying attention so as not to give
damage to the sensor.
(Standard frequency of cleaning: Once a month)
⋅ As for the cleaning of heavy soil, please consult your dealer.
• Proceed with maintenance work after the product has been
sufficiently cooled down.
• Be sure to set the power switch to OFF before starting
maintenance work.
CAUTION
Make sure
of power-OFF.
Temperature sensor
Drain port
Heater
(Plan of bottom of chamber inside)
Chamber opening
Cover packing
To Next Page
Loading...
Need help?
General
