Sanyo PLC-ET30L User Manual

17
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See “Remote control” in the Setting Menu on page 52.
Press and hold the MENU and a number button (1–8)
for more than five seconds to switch between the
codes.
1
To initialize the remote control code, slide the RESET/
ON/ALL-OFF switch to “RESET,” and then to “ON.” The
initial code is set to Code 1.
2
Press and hold the MENU and a number button
(1–8) that corresponds to the remote control code
for more than five seconds to switch between
the codes.
MENU button
Remote Control Code
Number buttons
RESET/ON/ALL OFF
Switch
Part Names and Functions

Sanyo PLC-ET30L Specifications

General

Brightness	3000 ANSI Lumens
Resolution	1024 x 768 (XGA)
Contrast Ratio	500:1
Lamp Life	2000 hours (Normal Mode), 3000 hours (Eco Mode)
Display Type	LCD
Display Technology	3LCD
Aspect Ratio	4:3
Projection Size	30 - 300 inches
Input Ports	S-Video
Output Ports	Audio (Mini Jack)
Operating Temperature	5 - 35 °C