Sanyo PLC-WR251 - True WXGA Projector - Computer Input; Input Source Selection (Computer 1: RGB)

27
Choose Computer 1(RGB) by pressing the INPUT button on the top control or press the COMPUTER 1 button
on the remote control.
Before using INPUT button, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB )
Computer Input
Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
Computer
1
Top Control
Direct Operation
Menu Operation
Press the MENU button to display the On-Screen
Menu. Use the Point  buttons to select Input and
then press the Point  or the SELECT button.
Use the Point  buttons to select Computer 1.
When Computer 1 is selected, press the Point 
button to access the submenu items. Use the Point 
 buttons to select the RGB input source and then
press the SELECT button.
COMPUTER 1 button
Remote Control
Computer 1(RGB)
Computer 1(Scart)
INPUT button
Computer 1
HDMI
Computer 2

S-video
Video

COMPUTER 2 can not be selected when using the COMPUTER IN 2/
MONITOR OUT terminal as MONITOR OUT output.