68
The image is distorted or runs off. – Check PC adjust menu or Screen menu and adjust them.
See pages 31-32, 35-36.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up. you have set). See pages 19, 56-57.
The Remote Control does – Check the batteries.
not work. – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 55.
– Unlock the Key lock function for the remote control function. See
page 56.
Indicator blinks or lights. – Check the status of the projector with referring to "Indicators and
projector Condition". See page 72.
The exclamation mark appears – Your operation is invalid. Operate correctly.
on the screen.
Top control does not work. – The top control is not available if the top control is locked at Key lock
under Security of SETTING section. See page 56.
Unable to unlock the Logo PIN – Contact the dealer where you purchased the projector or the service
code lock, Security key lock center.
or Security PIN code lock.
Appendix
Appendix
To Next Page
Loading...
