Sanyo PLC-XF46N - Page 22

- 22 -
Mechanical Disassemblies
Control Button
Control Panel
Control Board
4-4
Control Switch unit disassemblies.
1. Remove 4 screws, remove the Control Button and remove the Control Board.
(See Fig.4-4)
Fig.4-4
4-5
Terminal Board DVI disassemblies.
1. Remove 2 screws-A, remove screw-B, remove screw-C, and remove the Terminal Board DVI.
2. Remove 2 screws-D, remove the Holders and remove the Earth BRKT Slot.
3. Remove 4 screws-F and remove the Handles.
(See Fig.4-5)
A
A
B
C
D
D
F
F
F
F
Terminal board DVI
Holder
Holder
Handle
Handle
Panel
Earth BRKT Slot
Fig.4-5