Sanyo PLC-XF46N - Page 31

- 31 -
Optical Unit
B
B
B
B
A
A
A
A
A
A
A
A
A
A
FN906
The direction
of a wind
Adjustable
foot-left
Adjustable
foot-right
A
A
A
A
A
A
B
B
B
B
B
B
C
C
Holder FN
PWB Holder
D
D
D
D
E
E
E
C
C
Fan(FN906) unit
F
Rear LED Board
6
Optical Unit removal.
1. Remove 10 screws-A, remove 4 screws-B and remove the Optical unit.
(See Fig.6)
Warning;
Do not hold the projection lens.
It may damage projection lens.
7
-1
Fan(FN906) Unit and Adjustable-feet removal.
1. Remove 6 screws-A and remove the Adjustable-foot-left.
2. Remove 6 screws-B and remove the Adjustable-foot-right.
3. Remove 2 screws-C and remove the Fan(FN906) Unit.
4. Remove 4 screws-D and remove the Fan(FN906).
5. Remove 3 screws-E and remove the Rear LED Board.
6. Remove screw-F and remove the PWB Holder.
(See Fig.7-1, 7-1a)
Note;
Mark the Fans as they are removed from the holder so that
they may be reassembled in the same location from which
they were removed. Be careful of the attached direction of
Fans.
See arrow mark in a figure.
Fig.6
Fig. 7-1
Fig. 7-1a
Mechanical Disassemblies
Warning!
Do not hold the Projection lens