-146-
PIN NO. NAME FUNCTION NAME FUNCTION POLARITY I /O
205 LCD10 / PTC[6] / PINT[2] SH_SCL_Slot4 IIC Bus (Slot4) "L" : Active IO
206 LCD9 / PTC[5] / PINT[1] SH_SDA_Slot3 IIC Bus (Slot3) "L" : Active IO
207 VssQ GND
208 LCD8 / PTC[4] / PINT[0] SH_SCL_Slot3 IIC Bus (Slot3) "L" : Active IO
209 VccQ 3.3V
210 LCD7 / PTD[3] SH_SDA_3V IIC Bus "L" : Active IO
211 LCD6 / PTD[2] SH_SCL_3V IIC Bus "L" : Active IO
212 LCD5 / PTC[3] SH_SDA_Slot2 IIC Bus (Slot2) "L" : Active IO
213 LCD4 / PTC[2] SH_SCL_Slot2 IIC Bus (Slot2) "L" : Active IO
214 LCD3 / PTC[1] SH_SDA_Slot1 IIC Bus (Slot1) "L" : Active IO
215 LCD2 / PTC[0] SH_SCL_Slot2 IIC Bus (Slot2) "L" : Active IO
216 LCD1 / PTD[1] SH_SDA_S3V IIC Bus (Slot2) "L" : Active IO
217 LCD0 / PTD[0] SH_SCL_Slot2 IIC Bus (Slot2) "L" : Active IO
218 DREQ0 / PTD[4] PW_SH_0 PW --> SH Input signal I
219 LCK / UCLK PTD[6] UCLK USB Clock (48MHz) I
221 CA not used Hardware Stand-BY Demand I
222 MD3 MD3 Bus Widht setting for Area 0 "L" : Always I
223 MD4 MD4 Bus Widht setting for Area 0 "H" : Always I
224 Scan_testen 3.3V Test Terminal I
225 AVcc_USB 3.3V USB Analog Power
226 USB1_P (analog) USB1P [Func] USB1 Data Output (+) IO
227 USB1_M (analog) USB1M [Func] USB1 Data Output (-) IO
228 AVss_USB GND
229 USB2_P (analog) not used USB2 Data Output (+) IO
230 USB2_M (analog) not used USB2 Data Output (-) IO
231 AVcc_USB 3.3V USB Analog Power
232 AVss GND
233 AN[2] / PTL[2] DUAL_SENS Pressure Sensor / WInd Sensor AI
234 AN[3] / PTL[3] TEMP_SENS Temperature Sensor Input AI
235 AN[4] / PTL[4] KEY1 KEY AD Converter Input AI
236 AN[5] / PTL[5] KEY2 KEY AD Converter Input AI
237 AVcc 3.3V
238 AN[6] / PTL[6] / DA[1] KEY3 KEY AD Converter Input AI
239 AN[7] / PTL[7] / DA[0] OPT1 Option Resister AI
240 AVss GND
● IIC Bus DA Converter (IC7801 M62393FP)
PIN NO. NAME FUNCTION NAME FUNCTION POLARITY I /O
12 A1 DACFANCONT1 0 ~ 255 = 13.8~ 6.0 V O
13 A2 DACFANCONT2 0 ~ 255 = 13.8~ 6.0 V O
14 A3 DACFANCONT3 0 ~ 255 = 13.8~ 6.0 V (not used) O
15 A4 DACFANCONT4 0 ~ 255 = 13.8~ 6.0 V (not used) O
4 A5 DACFANSW1 ON : 255 / OFF 0 O
5 A6 DACFANSW2 ON : 255 / OFF 0 O
6 A7 DACFANSW3 ON : 255 / OFF 0 (not used) O
7 A5 DACFANSW4 ON : 255 / OFF 0 (not used) O
● Parallel Bus I/O Expander (IC5861 FPGA_NIOS EP2C5F256C)
PIN NO. NAME FUNCTION NAME FUNCTION POLARITY I/O
P8 LENSE_OUT [7] ZOOM + Zoom UP "L" : Stop / "H" : Move O
T9 LENSE_OUT [6] ZOOM - Zoom Down "L" : Stop / "H" : Move O
L9 LENSE_OUT [5] FOCUS + Focus UP "L" : Stop / "H" : Move O
N9 LENSE_OUT [4] FOCUS - Focus Down "L" : Stop / "H" : Move O
L10 LENSE_OUT [3] LENS UP Lens Shift Up "L" : Stop / "H" : Move O
N10 LENSE_OUT [2] LENS DOWN Lens Shift UDown "L" : Stop / "H" : Move O
R10 LENSE_OUT [1] LENS L Lens Shift Left "L" : Stop / "H" : Move O
T10 LENSE_OUT [0] LENS R Lens Shift Right "L" : Stop / "H" : Move O
N8 LENSE_DET [5] LENS TOP Lens Shift Upper Limit Detect "L" : Lens Bottom Arrival I
L8 LENSE_DET [4] LENS BTM Lens Shift Lower Limit Detect "L" : Lens Top Arrival I
T8 LENSE_DET [3] LENS LE Lens Shift Left Limit Detect "L" : Lens Right Arrival I
L7 LENSE_DET [2] LENS RE Lens Shift Right Limit Detect "L" : Lens Left Arrival I
R8 LENSE_DET [1] LENS VC Lens Shift U/D Center Limit Detect I
T7 LENSE_DET [0] LENS HC Lens Shift R/L Center Limit Detect I
T6 LAMP_RX [3] LAMP4_RX Lamp4 Data Receive "H" : ON / "L" : OFF I
T5 LAMP_RX [2] LAMP3_RX Lamp3 Data Receive "H" : ON / "L" : OFF I
R7 LAMP_TX [3] LAMP4_TX_EX Lamp4 Data Send O
R5 LAMP_TX [2] LAMP3_TX_EX Lamp3 Data Send O
Control Port Functions
To Next Page
Loading...
