Sanyo PLC-XK2600 - Page 57

57
,QIRUPDWLRQ
,QSXW6RXUFH,QIRUPDWLRQ'LVSOD\
The Information Menu is used for checking the status of the image signal being projected and the operation of the
projector.
+V\QFIUHT
9V\QFIUHT
Lamp counter
,QIRUPDWLRQ0HQX
The horizontal frequency of the input signal is
displayed in .+],or- - - - .+]when no signal.
The vertical frequency of the input signal is displayed
in +],or+]when no signal. Numbers of Hz
doubles when during Interlace.
The cumulative lamp operating time is displayed.
Press the INFO. button on the remote control to display
the Information Menu.
,1)2EXWWRQ
5HPRWH&RQWURO
Press the Point Ÿź buttons to select the Information.
The Information Menu is displayed.
See below for displayed information.
Power management
Screen
2II, 5HDG\ or 6KXWGRZQ, and 7LPHU are displayed.
The selected screen size is displayed.
,QSXW
Lamp status
The selected input source is displayed.
The selected lamp mode is displayed.
Language
The selected language is displayed.
.H\ORFN
The selected Key lock icon is displayed.
3,1FRGHORFN
2II or On1 or On2 is displayed.
5HPRWHFRQWURO
The selected remote code is displayed.
Direct Operation
Menu Operation
6(5,$/12
The serial number of the projector is displayed. The
serial number is used to service the projector.