Sanyo PLC-XK2600 - Page 65

65
$SSHQGL[
 7KHLPDJHLVGLVWRUWHGRUUXQVRII – Check PC adjust menu or Screen menu and adjust them.
See pages 30-31, 34-35.
 3,1FRGHGLDORJER[DSSHDUV – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up. you have set). See pages 19, 53-54.
 7KH5HPRWH&RQWUROGRHV – Check the batteries.
not work. – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 52.
– Unlock the Key lock function for the remote control function.
See page 53.
,QGLFDWRUEOLQNVRUOLJKWV – Check the status of the projector with referring to "Indicators and
projector Condition". See page 69.
7KHH[FODPDWLRQPDUNDSSHDUV – Your operation is invalid. Operate correctly.
RQWKHVFUHHQ
 7RSFRQWUROGRHVQRWZRUN– The top control is not available if the top control is locked at .H\ORFN
under 6HFXULW\ of SETTING section. See page 53.
8QDEOHWRXQORFNWKH/RJR3,1 – Contact the dealer where you purchased the projector or the service
FRGHORFN6HFXULW\NH\ORFN center.
RU6HFXULW\3,1FRGHORFN
– The projector detects an abnormal condition. Unplug the AC power cord
and contact the dealer where you purchased the projector or the service
center.
appears on the screen