Sanyo PLC-XM100 Network Manual

3
ENGLISH
Safety instructions
CAUTION IN USING THE PROJECTOR VIA NETWORKS
● When you find a problem with the projector, remove the power cable
immediately and inspect the unit. Using the projector with failure may cause
fire or other accidents.
● If you remotely use the projector via networks, carry out a safety check regularly
and take particular care to its environment. Incorrect installation may cause fire
or other accidents.
CAUTION IN USING NETWORK FUNCTION
● SANYO Electric Co., Ltd. assumes no responsibility for the loss or damage of
data, or damage of the computer caused by using this projector. Making back-
up copies of valuable data in your computer is recommended.

Sanyo PLC-XM100 Specifications

General

Vertical scan range	48 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Aspect ratio	4:3
RS-232 ports	1
Dimensions (WxDxH)	497.8 x 375.9 x 165.1 mm
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Focus	Manual
RMS rated power	7 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	31 dB

Weight and Dimensions

Weight	9661.5 g