Sanyo PLC-XM150 - Menu Operation

34
INPUT MENU
When your computer is connected to INPUT 1 (DIGITAL)
terminal, select RGB(PC digital).
When your computer is connected to the INPUT 1 (ANALOG)
terminal, select RGB (PC analog).
RGB(PC digital)
RGB(PC analog)
3Note:
• Input source changes if the INPUT 1 button on the remote control is
pressed.
• HDCP (High-bandwidth Digital Content Protection) is a system for
protecting digital entertainment content which is delivered by DVI
(Digital Visual Interface) from being copied. The specification of HDCP
is decided and controlled by Digital Content Protection, LLC. Should
the specification be changed, this projector may not display the digital
content protected by HDCP.
When connecting the computer output [5 BNC Type (Green, Blue,
Red, Horiz. Sync, and Vert. Sync.)] from the computer to G, B, R,
H/HV, and V jacks:
Input Selection
When your computer is connected to the INPUT 2 (5 BNC
INPUT JACKS) terminal, select RGB.
RGB
1
2
3
Input 1 RGB(PC analog)
Input 2 RGB
Input 3 Video
System SVGA 1
Press the MENU button to display the On-Screen Menu. Use
WKH3RLQWŸźEXWWRQVWRVHOHFWInput and then press the
3RLQWŹRUWKH6(/(&7EXWWRQ
8VHWKH3RLQWŸźEXWWRQVWRVHOHFWWKHGHVLUHGLQSXWDQG
WKHQSUHVVWKH3RLQWŹEXWWRQWRDFFHVVWKHVXEPHQXLWHPV
8VHWKH3RLQWŸźEXWWRQVWRVHOHFWWKHGHVLUHGVRXUFH and
then press the SELECT button.
INPUT 2 MENU
INPUT 1 MENU
Computer Input Source Selection
WHEN SELECTING INPUT 1 (COMPUTER INPUT
TERMINALS )
WHEN SELECTING INPUT 2 (5 BNC INPUT JACKS )
Menu Operation