What to do if Sanyo PLC-XU350A cannot be turned on after cooling?
If your Sanyo Projector has been cooled down enough but cannot be turned on and the WARNING indicator keeps blinking, check and clean the air filter.
Why Sanyo PLC-XU350A Projector cannot be turned on until cooling is completed?
If the Sanyo Projector cannot be turned on until cooling is completed and the POWER indicator stops blinking, it means that the projection lamp is being cooled down. Wait until cooling is completed and the POWER indicator stops blinking.
What does it mean when the WARNING indicator light is red on Sanyo Projector?
If the WARNING indicator light is red on your Sanyo Projector, the projector has detected an abnormality in the cooling fan operation or in the power supply secondary circuits. Check the fan operation, power supply lines, and the driving signal status.
Why my Sanyo PLC-XU350A cannot be turned on due to high temperature?
If your Sanyo Projector cannot be turned on due to abnormally high temperature, wait until it cools down enough for the temperature to return to normal. When this happens, the POWER indicator will emit a red light, and you will be able to turn on the projector. Also, check and clean the air filter.
What to do if WARNING and POWER indicators are flashing on Sanyo PLC-XU350A Projector?
If the WARNING (red) and POWER (red) indicators are flashing on your Sanyo Projector, this indicates that the projector has detected an abnormally high temperature inside. You should check the air filters, remove any obstructions near the intake and exhaust fan openings, and then wait for the POWER indicator to stop flashing.
How to fix a Sanyo PLC-XU350A that is off?
If the Sanyo Projector is off, make sure the AC power cord is properly plugged into the power outlet.
How to fix auto setup if it does not work properly on my Sanyo PLC-XU350A?
If the auto setup feature on your Sanyo Projector isn't working correctly, ensure that 'Off' is not selected for any function within the Auto setup menu. Also, verify that 'On' is not selected for the Ceiling function.
How to troubleshoot no sound on Sanyo PLC-XU350A Projector?
If there is no sound from your Sanyo Projector, check if the audio signal is observed at pins 7 and 15 of IC5001.
General| Brightness | 3500 ANSI Lumens |
|---|---|
| Contrast Ratio | 2000:1 |
| Display Technology | LCD |
| Aspect Ratio | 4:3 |
| Projection Size | 30 to 300 inches |
| Zoom Ratio | 1.2x |
| Resolution | 1024 x 768 pixels (XGA) |
| Lamp Life | 2000 hours (Standard Mode) / 3000 hours (Eco Mode) |
| Throw Distance | 1.2 m |
| Input Ports | S-Video, Composite Video |
| Output Ports | Audio |
Step-by-step guide to power on the projector.
Instructions on navigating and using the on-screen menu.
Step-by-step guide for replacing the projection lamp.
Solutions for common projector problems.
Detailed technical specifications of the projector.
Steps to install the PJ Network Manager software.
To Next Page
