Sanyo PLC-XU88 - How to Operate the On-Screen Menu

23
Basic Operation Basic Operation
How to Operate the On-Screen Menu
The projector can be adjusted or set via the On-Screen
Menu. For each adjustment and setting procedure, refer to
the respective sections in this manual.
Use the Point◄► buttons to select a Menu icon. Use
the Point ▲▼ buttons to select an item in the selected
menu.
Press the SELECT button to show the item data. Use
the Point ◄► buttons to adjust the values.
To close the On-Screen Menu, press the MENU button
again.
Press the MENU button on the top control or the
remote control to display the On-Screen Menu.
Note:
• The selected item is not active until the SELECT button
is pressed.
1
2
3
On-Screen Menu
Top Control
MENU button
POINT buttons
Remote Control
SELECT button
MENU button
SELECT button
POINT buttons
Menu bar Pointer
(red frame)
Menu icon
Item data
Press the Point
◄►buttons to adjust
the value.
SELECT
button
Pointer (red frame)
Press the Point
▲▼ buttons
to move the pointer.
Item
Quit
Exit this menu.