Video Input
Use the Point ◄► buttons to adjust the gamma value to
obtain a better balance of contrast (from 0 to 15).
Gamma
Press the Point ◄ button to decrease the sharpness of the
image; press the Point ► button to increase the sharpness
of the image (from 0 to 15).
Sharpness
An interlaced video signal can be displayed in progressive
mode. Select one of the following options.
Off .......... Disabled.
L1 .......... For an active picture.
L2 .......... For a still picture.
Film ........ For watching a film. With this function, the
projector reproduces pictures faithful to the
original film quality.
Progressive
Noise reduction
Noise interference on the screen can be reduced. Select
one of the following options to get smoother images.
Off .......... Disabled.
L1 .......... Lower reduction
L2 .......... Higher reduction
Notes:
• Noise reduction and Progressive cannot be
selected when 480p, 575p, 720p, 1035i, or 1080i
is selected (p.41).
•
Reset and Store icons will be displayed when any
adjustment is made.
To store the adjusted data, select Store and press the
SELECT button. Use the Point ▲▼ buttons to select one
from Image 1 to 4 and press the SELECT button.
A confirmation box appears and then select [Yes]. Stored
data can be called up by selecting an “Image (1–4)” in the
Image Select Menu on page 42.
To reset the adjusted data, select Reset and press the
SELECT button. A confirmation box appears and then select
[Yes]. All adjustments will return to their previous figures.
Reset
Store
Exit the Image Adjust Menu.
Quit
Image Mode Menu
Move the red frame
pointer to an image
item to be set and
t h e n p r e s s t h e
SELECT button.
Store icon
A confirmation box
appears and then
select [Yes].
Video Input
To Next Page
Loading...
Need help?
General
