-12-
■ Mechanical Disassemblies
7. LAMP BALLAST UNIT REMOVAL
1. Remove four screws A to take the Lamp Ballast Cover
upward off.
2. Remove the screw B to disconnect the Lamp Ballast
Socket.
3. Remove five screws C to take the Lamp Ballast Unit off.
Lamp Ballast Unit
Fig. 7
A
A
A
A
B
C
C
C
C
C
Lamp Ballast Cover
8. POWER UNIT, R/C BOARD, AND FANS REMOVAL
1. Remove five screws A to take the Power Unit upward
off.
2. Remove three screws B to take the Power Unit Ass’y
upward off.
3. Remove two screws C to take the Fan (FAN904) off.
4. Remove two screws D to take the Fan (FAN903) off.
Fig. 8
A
Power Unit
R/C
A
A
A
A
B
B
B
C
C
D
D
Power Unit Ass’y
FAN904
FAN903
Note:
The transparent plates are fixed between the Lamp Ballast Unit and the Power Unit to
control the flow of air by the fans. After servicing, fix them to previous position.
To Next Page
Loading...
