Sanyo PLV-Z3 - Electrical Adjustment; Service Adjustment Menu Operation

-23-
Normal Mode "S" mark display
MENU
Service Mode
INPUT Video
Image Powerful
Group No. Data
SANYO
0 280
1.00 JAPAN
TempB TempC
46.78 34.56
102
Ver
TempA
23.45
Fan1 Speed Fan2 Speed Fan3 Speed Fan4 Speed
35 100 100 100
Service Mode
Service mode
+
DOWN
POWER
ON-OFF
INPUT
UP
+
S
◆ To enter service mode
To enter service mode, press and hold the "MENU" and
"INPUT" buttons on the projector simultaneously for 5 sec-
onds. The "S" mark appears on the screen. While the "S"
mark is displayed on the screen, press and hold the "
POINT UP"and "POINT DOWN" buttons on the projector
or "SCREEN" button on the remote control unit for more
than 3 seconds. As shown in a figure, a service mode dis-
play appears on a screen.
◆ To adjust service data
Adjust service data using the following control buttons.
– "SELECT" ....................A group number increases.
– "MENU" ......................A group number decreases.
– "POINT UP" ................An item number increases.
– "POINT DOWN" ..........An item number decreases.
– "POINT RIGHT" ..........An adjustment value increases.
– "POINT LEFT" ............An adjustment value decreases.
◆ To exit service mode
To quit the service mode, press the "POWER ON/OFF"
button only once on the projector or the remote control
unit .
POWER
WARNING
LAMP
REPLACE
MENU
INPUT
SELECT
ON-OFF
● Service Adjustment Menu Operation
LL
LIGHT
RESET
MENU
CANCEL
SCREEN
IMAGE ADJ.
SELECT
Remote Control
Top Control
■ Electrical Adjustment