Sanyo VHR-310 - Notes on Timer Recording Setting; Copying a Tape

i
TIMER RECORDING PROGRAMMING
The timer recording will not operate if...
● A cassettewith no erasure-prevention tab is loaded.
The (Q) indicator will flash and the cassette will be ejected,
Programme priority
}
If several timer recordings have overlapping recording
times, the recording with the earliest start time will be
recorded first, until the end.
19:00 2000 21:00 22:00 2300
~
These positions will not be recorded
Notes:
● TO stop a timer recording, press the ■ STOP button.
● If 6 timer recordings have been set, you will first have to
erase one of the programmed timer recordings (see page
10) before you can set a new timer recording.
COPYING A TAPE
Copying (dubbing) a tape can be done using two video
recorders, a playback VCR and a recording VCR.
A
0 ----- . - . - . . ---- .-...---,
,
,
,
a
,
,
*
220-240V AC
,
,
.. . . . . . . . . . . . . . . . . . . . . ..’
Connect VCR A (or Camcorder) and VCR B.
Insert the pre-recorded tape into VCR A (playback
Inseri the blank video cassette into
VCR B (recording
Set the VCR B tothe “AV” mode.
Setting the VCR to the “AV” mode.
❑ Press
the OIAV button once to display “AV” instead of a
channel position number or,
❑ Press the CHANNEL (- or +) buttonto display“AV” instead
of a channel positionnumber.
Set VCR B to recordpause mode. (The recordpause -
mode is set by pressingthe ● REC buttonthen the
II PAUSEKTILL button.)
Start playback on VCR A by pressing the PLAYb
When the desired starting position is reached on VCR
A, start recording
on VCR B by pressingthe
II PAUSE/STILL buttonor the ● REC
button.
When the copy is completed, press the
■ STOP button
on VCR B then on VCR A.
11
——
.—