TROUBLESHOOTING
This VCR is highly sophisticated. It is shipped from the factory after having been checked
and adjusted under the most rigid quality control and inspection system. Should problems
occur, check the following points.
The remote control
I
● The batteries are low.
unit doesn’t oDerate
.
I
No TV programmed
● Are the connections between your VCR and TV correct?
received
● Was tuning correctly preset?
Off the air reception
● The video channel setting of the TV receiver does not
on the VCR is poor
correspond to the video channel presetting of the VCR.
Playback picture does
● The video channel setting of the TV receiver does not
not appear
correspond to the video channel presetting of the VCR.
Interference
in
● Adjust the tracking control.
playback picture
● Dust or dirt on video heads. Take the VCR to an Authorized
Service Station or dealer.
No
recording
● The erasure-prevention tab on the cassette has been
removed.
Timer recording is not
● The startingday and time have not been set correctly.
possible
● The clock time is not set correctly.
● There has been a power interruption of more than 60
minutes.
13
To Next Page
Loading...
