2
Press the flash button to select the flash mode.
œ Each time the flash button is pressed, the flash mode icon changes.
3
Press the shutter release button.
œ The image is captured in the desired flash mode.
<Shooting without using the LCD monitor>
1
Press the flash button.
œ The LCD monitor turns on briefly to show the currently set flash
mode.
2 Press the flash button within 5 seconds to set the desired flash mode.
NOTE
In the automatic flash mode...
œ In the automatic flash mode using the LCD monitor, when the shutter
release button is depressed halfway, a f icon appearing in the upper
right area of the LCD monitor indicates that the flash will operate.
Flash button Flash
SX714/EX, GX, U (VPC-S1 GB) Thu. July, 17/2003
English
60
To Next Page
Loading...
Need help?
General
