Need help?Do you have a question about the SANYU SY5000 Series and is the answer not in the manual?
Essential safety guidelines for installing and operating the VFD equipment to prevent hazards.
Details protective functions, operating environment conditions, and structural specifications.
Covers DANGER/CAUTION warnings and essential operation environment requirements for VFD installation.
Illustrates the basic wiring diagram for VFD running, including major and control loops.
Shows the major loop terminal diagram for VFD connections.
Illustrates control loop terminals and details their functions in a table.
Details the function and purpose of each key on the VFD's operation panel for control and navigation.
Details the D Group monitoring parameters, including output frequency, current, voltage, and speed.
Defines basic run parameters like user password, software versions, and VFD rated power.
Specifies VFD type (G/P) and control modes (V/F, vector control) for motor operation.
Configures operation command channels and main frequency sources.
Covers acceleration/deceleration modes (linear, S-curve), stop modes, and related timing parameters.
Selects motor type and configures electrical parameters like rated power, frequency, speed, voltage, and current.
Configures speed loop parameters (ASR1, ASR2) including proportional gain, integral time, and filter constants.
Selects predefined or user-defined V/F curves and defines frequency/voltage points.
Explains VFD fault indications, alarm lights, and provides a guide for diagnosing and resolving issues.
Lists common fault codes (E-01 to E-30), their causes, and recommended actions for troubleshooting.
Addresses issues when the motor is not running or cannot accelerate/decelerate properly, suggesting checks and adjustments.
Outlines routine checks for abnormal sounds, heat, temperature, current, and cooling fan operation.
To Next Page
General
