7
Overview of the Models
The hardware configuration consists of either a Combics 1 or 2 indicator and
Sartorius weighing platform(s), or a Combics 1 or 2 indicator and weighing
platform(s) (strain-gauge load cells) from another manufacturer.
Important: Mechanical and electrical service or repair work on the Combics scale requires
considerable experience, and for this reason should be performed only by
Sartorius technicians trained at the factory. Any attempt to perform repair work
can result in damage to the equipment.
Auxiliary Service Tools and Equipment
In addition to standard tools, you will need the following special tools to work on
the Combics scale:
Qty. Designation Order No.
1 Laptop
1 Sartocas service software, version 1.46 or later 6740-33
or
1 Psion Server version 4.10 or later
1 PPLoader software
1 Isolating transformer
1 Flintec LCT-01 load cell tester
1 Socket wrench, double hexagon, 10-32 mm,
“ square driver
1 Adapter for Allen screws, SW 5 - 17, ” square driver
To Next Page
Loading...
Need help?
General
