136 Operating Instructions Combics Indicators
Menu Structure
Combics 1 application menu
* = Factory setting
Applic. WEIGH.
param.1
min.init Minimum load for automatic taring 3.5
1 digit 1 digit* 3.5.1
2 digit 2 digits 3.5.2
5 digit 5 digits 3.5.3
10 digT. 10 digits 3.5.4
20 digT. 20 digits 3.5.5
50 digT. 50 digits 3.5.6
100 dIG. 100 digits 3.5.7
200 dIG. 200 digits 3.5.8
500 dIG. 500 digits 3.5.9
1000 dI. 1000 digits 3.5.10
aut.tare Automatic taring: first weight tared 3.7
OFF Off 3.7.1
ON On 3.7.2
TARE.FNC Tare function 3.25
normal Can add a preset tare if tare value is available;
however no tare function possible 3.25.1*
special When a preset tare is entered, the tare value is deleted;
however, tare function activation is possible 3.25.2
RESET Restore all applications to factory default settings 9.1
YES Yes (restore factory settings) 9.1.1
NO No (retain user-defined settings) 9.1.2*
Combics 2 application menu
* = Factory setting
Applic./Applic.1 WEIGH. Weighing
min.init Minimum load for automatic taring 3.5
1 digit 1 digit* 3.5.1
2 digit 2 digits 3.5.2
5 digit 5 digits 3.5.3
10 digT. 10 digits 3.5.4
20 digT. 20 digits 3.5.5
50 digT. 50 digits 3.5.6
100 dIG. 100 digits 3.5.7
200 dIG. 200 digits 3.5.8
500 dIG. 500 digits 3.5.9
1000 dI. 1000 digits 3.5.10
aut.tare Automatic taring: first weight tared 3.7
OFF Off 3.7.1
ON On 3.7.2
Applic./Applic.1 Count. Counting
min.init Minimum load for application 3.6
1 digit 1 digit 3.6.1*
2 digit 2 digits 3.6.2
... see “Weighing"
1000 dI. 1000 digits 3.6.10
RESOLUT Resolution for calculation of reference piece weight 3.9
DISP.ACC Display accuracy 3.9.1*
10 FOLD Plus 1 decimal place (10 fold) 3.9.2
100 FOLD Plus 2 decimal places (100 fold) 3.9.3
SAVE WT. Parameter for saving weight values 3.11
STABIL. With stability 3.11.1*
ACC.STAB With increased stability 3.11.2
REF.UPDT Reference sample updating 3.12
OFF Off 3.12.1
AUTOMAT Automatic 3.12.2*
To Next Page
Loading...
Need help?
General
