Sartorius combics 1 - Combining Application Programs

Combining Application Programs
The following table shows how the applications described can be combined.
The basic weighing function is available at all times; it does not need to be
combined with a computational function.
Select programs one after the other: Toggle using the D key
Application 1 (Basic Function) Application 2 (Monitoring Function) Application 3 (Cumulative-value
Function)
Counting – Totalizing
Counting Checkweighing Totalizing
Counting Checkweighing –
Counting Classifi cation –
Neutral Measurement – Totalizing
Neutral Measurement Checkweighing Totalizing
Neutral Measurement Checkweighing –
Neutral Measurement Classifi cation –
Animal Weighing – Totalizing
Animal Weighing Checkweighing Totalizing
Animal Weighing Checkweighing –
Animal Weighing Classifi cation –
Weighing in Percent – Totalizing
Weighing in Percent Checkweighing Totalizing
Weighing in Percent Checkweighing –
Weighing in Percent Classifi cation –
– – Net-total Formulation
– Checkweighing Totalizing
Example: “Portioning" (counting z, checkweighing O with totalizing s)
Confi guration:
Application 1: Counting (COUNT.)
Application 2: Checkweighing (CHECK.)
Application 3: Totalizing (TOTALIZ): Saved value: Net + Calculated (3.23.3)
Autosave: On (3.16.2)
Source of data: Application 2 (3.22.2)
Setup: Printout: PRT PROT 7.8. Printer 1: “Total printout: Print when FN
pressed,” then select the menu line items of your choice.
t Place empty container on the scale.
) t Tare the scale.
This is not required if the automatic tare function is active. The tare
weight is saved automatically when you place the container on the
platform.
Operating Instructions Combics Indicators 93
Operation