Sartorius combics 1 Operating Instructions

48 Operating Instructions Combics Indicators
Operation
(
1.) Zero the scale.
J
2.) Start calibration
(e.g., when adjustment
prompt flashes WP).
cal.Ext. is displayed for
two seconds.
You are prompted to place
the required weight on the
platform (e.g., 10,000 g).
3.) Place the calibration/-
adjustment weight on the
weighing platform.
The difference between
the measured value and the
true weight of the sample
will be displayed with plus/
minus signs.
Ext. calibration A printout will be
Nom. + 10000 g generated if the process
Diff. + 1 g is cancelled using the (
J 4.) Activate calibration adjust-
ment (press the ( key to
cancel).
The adjustment weight
is displayed once adjust-
ment is finished.
-------------------- A GMP-compliant
24.02.2012 10:15 printout is generated.
Type CAISL2
Ser.no. 12345678
Vers. 1.0103.11.2
BVers. 01-26-02
--------------------
Ext. calibration
Tar + 10000 g
Diff. + 1 g
Ext. adjustment
Diff. + 0 g
--------------------
24.02.2012 10:15
Name:
--------------------
Example:
External calibration and manual adjustment with default weights (weighing parameters: factory settings)
Example 2
External calibration and manual adjustment with freely configurable adjustment weight (within the limits of 1/3 max. capacity to max. capacity)
(
1.) Set scale to zero.
J
2.) Start calibration (e.g.,
when adjustment prompt
flashes WP).
“cal.ext.” is displayed
for two seconds.
You are prompted to place the
calibration/adjustment weight on
the platform (e.g., 10,000 g).
5 + ) 3.) Enter the desired CAL weight
above the number block and
confirm with “)” (5,000 g here).
If the weight is too heavy or
too light, an error message will
appear.

Sartorius combics 1 Specifications

General

Brand	Sartorius
Model	combics 1
Category	Monitor
Language	English