Setting the Parameters (Menu Codes)
Example: Adapting the balance to “very unstable" ambient conditions (menu code 1 1 4).
Step Key (or instruction) Display
1. Switch off the balance. (E)
2. Switch the balance on; (E)
while all segments
are displayed: (TARE) briefly
1
$ Scroll upward within a (CAL) 2
menu level; after the last repeatedly ...
menu code, the first
9
code is displayed again. 1
3. Select menu level 2 (A) 1 1
(scroll to the right).
4. Select menu level 3 (A)
1 1 2
o
(scroll to the right).
5. Menu level 3: (CAL)
Scroll until the desired repeatedly
1 1 4
number is shown.
6. Confirm change; (TARE)
1 1 4
o
“o” on display indicates
active setting.
$ Return to higher menu level (A)
1
(from the third level).
$ Set other codes as desired. (A), (CAL)
7. Save changes and exit Press and hold
the menu (TARE) (> 2 sec.)
or
$ Exit menu without saving
changes. (E)
27
To Next Page
Loading...
Need help?
General
