Menu 1 through 3 see previous page
5 Data interface 5 1 Baud rate 511 150 baud
512 300 baud
513 600 baud
514 o 1,200 baud
515 2,400 baud
516 4,800 baud
517 9,600 baud
518 19,200 baud
5 2 Parity 521 Mark
522 Space
523 o Odd
524 Even
5 3 Number of stop bits 531 o 1 stop bit
532 2 stop bits
5 4 Handshake mode 541 Software
542 o Hardware,
2 char. after CTS
543 Hardware,
1 char. after CTS
5 5 Communication mode 551 SBI (ASCII)
1
)
552 o Universal printer
6 Print for 6 1 Manual/auto/mode 611 Manual without stability
weighing with (A) key
612 o Manual after stability
with (A) key
613 Manual at stability
with (A) key
614 Automatic without stability
615 Automatic at stability
616 Automatic when load
is changed
1
)
6 2 Stop automatic 621 Manual with (A) key
printing 622 o Not stoppable
6 3 Time-dependent 631 o 1 display update
autom. printing 632 2 display updates
6 4 Tare the balance 641 o Off
after ind. printout 642On
7 through 9 see next page
1
) = Note concerning balances verified for legal metrology:
On the “SBI” setting, the non-verified digit indicated is not automatically identified.
Be sure to take the steps or make the settings on the auxiliary device so that these digits are properly identified.
See also the “Interface Port” chapter on page 53.
2
) = Auto print when load change is > 10 d and stability is reached: no printout until residual difference in load
value is < 5 d
31
Menu level 1
Menu level 2
Menu level 3
Factory setting
Menu item
To Next Page
Loading...
Need help?
General
