59
Software Handshake
The software handshake is controlled via
XON and XOFF. When a device is switched
on, XON must be transmitted to enable
any connected device to communicate.
Data Output by Print Command
The print command can be transmitted
by pressing (A) or by a software command
(Esc P).
Automatic Data Output
In the “auto print" operating mode, data
is output to the interface port without
a print command. You can have data out-
put automatically at defined print intervals,
with or without the stability parameter.
The length of a print interval depends on
the settings for “Adapting the filter"
(1 1 x) and “Time-dependent automatic
printing" (6 3 x).
If you select the auto print setting, data
will be transmitted immediately the
moment you turn on the balance. In the
operating menu, you can define whether
automatic printing can be stopped by
pressing (A).
Faster Output Speeds
If you require output speeds faster
than 10 Hz, please contact Sartorius for
information.
To Next Page
Loading...
Need help?
General
