Operating Instructions Cubis
®
MCA 63
System Settings
7.7.4 Parameters in the “Weighing and Print Profiles / Weighing” Menu
Parameter Setting Values Explanation
Ambient
conditions
Very stable Sets the ambient conditions to “very stable”: Activates a fast
change in the weight values in the event of a load change with
ahigh output rate.
Recommended for the following work environment:
− Very stable table near the wall
− Closed and calm room
Stable Sets the ambient conditions to “stable”.
Recommended for the following work environment:
− Stable table
− Slight movement in the room
− Slight draft
Unstable* Sets the ambient conditions to “unstable”: Activates the delayed
change in weight values with a reduced output rate.
Recommended for the following work environment:
− Simple office desk
− Room with moving machinery or personnel
− Slight air movement
Very unstable Sets the ambient conditions to “very unstable”: Activates a
significantly delayed change in the weight values and long wait
for stability with a further reduction in the output rate.
Recommended for the following work environment:
− Noticeable and slow floor vibrations
− Noticeable building vibrations
− Weighed goods moved
− Very strong air movements
Application filter Weighing
(final readout)*
Activates a filter that enables a fast change in the display for very
fast load changes.
Display changes with minimal load changes (in the digit range)
occur more slowly.
Dosing (filling mode) Activates a filter that enables a very fast change in the display
with minimal load changes (e.g. when dosing or filling vessels).
Sensor mode (low filter) Activates a weak but fast filter that always behaves in the same
way for load changes (e.g. when dosing in automated systems).
Dynamic mode
(withoutfilter)
Deactivates the active application filter.
*Factory setting for the “Standard Weighing” factory-set weighing profile
To Next Page
Loading...
Need help?
General
