11
Assembly Procedure
1. Affix the column bracket with 4 screws
2. Install the column support leveling foot
3. Push the load cell cable into the column
4. Insert the column into the bracket holder
5. Affix the column with 2 screws
6. Insert the display and control unit retainer into the
column
7. Tighten the screw on the display and control unit
bracket
Battery-Powered Operation
To activate battery operation:
– Open the battery cover at the back of the Indicator.
– Insert 1.5 V size D dry-cell batteries (not included)
into the battery compartment.
– The battery symbol is displayed when the unit is
operating on battery power.
– If the battery symbol flashes, the battery power is
weak.
Replace the batteries (if using dry-cell batteries).
11
To Next Page
Loading...
