9
Setting Up the Scale
Connecting Electronic Peripheral Devices
§ Make absolutely sure to unplug the scale from AC
power or switch off (activate battery mode) before
you connect or disconnect a peripheral device (print-
er or PC) to or from the interface port.
Warm-up Time
To deliver exact results, the scale must warm up for
at least 30 minutes after
initial connection to AC power. Only after this time
will the scale have reached the required operating
temperature.
Transport Lock
– Under the metal frame structure there are four
safety overload protection pins (Note: not on all
platform models).
Before using the scale, rotate the nut (upwards) until
tight.
Place the load plate on the scale
9
To Next Page
Loading...
