27
Print Formats
The print output can be configured for three modes: short mode (option 1.3.1), long/
block mode (option 1.3.2) and continuous mode (option 1.3.3). The SBI interface,
explained in the section above, is available in all modes. Sample print outputs are given
below for all three printing options in different weighing modes.
Note: To configure serial communication settings and print output options, please refer
to “Configuration (Setup menu)”.
Refer to “Application Programs” to configure the display and control unit for different
weighing modes.
2727
Printing Options
Mode of operation Short print Block print (long print) Continuous mode
Normal weighing
mode
Net weight Gross weight
(if tare is active)
Tare weight
(if tare is active)
Net weight
Gross weight
(if tare is not active)
or
Net weight
(if tare is active)
Counting mode Net weight
Pcs
Ref. weight
Gross weight
(if tare is active)
Tare weight
(if tare is active)
Net weight
Pcs
Ref. weight
Pcs (as default)
Pressing the Gross/Net key
switches
to:
Gross weight
(if tare is not active)
or
Net weight
(if tare is active)
Checkweighing
mode
Net weight
Chk OK/LO/HI
Gross weight
(if tare is active)
Tare weight
(if tare is active)
Net weight
Chk OK/LO/HI
LL (lower limit)
HH (upper limit)
Press key to toggle between:
Gross weight (with unit 1)
and
Gross weight (with unit 2)
To Next Page
Loading...
