4
Warnings and Safety Information
This moisture analyzer complies with
the European Council Directives as
well as international regulations and
standards for electrical equipment,
electromagnetic compatibility, and the
stipulated safety requirements.
Improper use or handling, however,
can result in damage and/or injury.
To prevent damage to the equipment,
read these operating instructions
thoroughly before using your MA35
moisture analyzer. Keep these instruc-
tions in a safe place.
Follow the instructions below to
ensure safe and trouble-free operation
of your moisture analyzer:
! Use the moisture analyzer only for
performing moisture analysis on
samples. Any improper use of the
analyzer can endanger persons and
may result in damage to the analyzer
or other material assets.
! Do not use this moisture analyzer in a
hazardous area; operate it only under
the ambient conditions specified in
these instructions.
! If you use electrical equipment in
installations and under ambient
conditions subject to stricter safety
standards than those described in the
manual, you must comply with the
provisions as specified in the applica-
ble regulations for installation in your
country.
– The moisture analyzer may be operat-
ed only by qualified persons who are
familiar with the properties of the
sample to be analyzed.
! Make sure before getting started that
the voltage rating printed on the
manufacturer’s label is identical to
your local line voltage (see “Connect-
ing the Moisture Analyzer to AC
Power” in the chapter entitled
“Getting Started”).
– The analyzer comes with a power
supply that has a grounding conduc-
tor.
– The only way to switch the power off
completely is to unplug the power
cord.
– Position the power cord so that it
cannot touch any hot areas of the
moisture analyzer.
– Use only extension cords that meet
the applicable standards and have a
protective grounding conductor.
– Disconnecting the ground conductor is
prohibited.
– Connect only Sartorius accessories
and options, as these are optimally
designed for use with your moisture
analyzer.
Note on installation:
The operator shall be responsible
for any modifications to Sartorius
equipment or connections of cables
not supplied by Sartorius and must
check and, if necessary, correct these
modifications. On request, Sartorius
will provide information on the
minimum operating specifications.
– Protect the analyzer from contact with
liquid
– If there is visible damage to the
equipment or power cord, unplug the
equipment and lock it in a secure place
to ensure that it cannot be used for
the time being.
To Next Page
Loading...
