Need help?Do you have a question about the Sartorius Research RC 250 S and is the answer not in the manual?
General| Capacity | 250 g |
|---|---|
| Readability | 0.1 mg |
| Display | LCD |
| Repeatability | 0.1 mg |
| Linearity | ±0.2 mg |
| Operating Temperature | +10°C to +30°C |
| Pan Size | 80 mm |
| Calibration | External |
| Power Supply | AC Adapter |
| Interface | RS-232 |
| Relative Humidity | Up to 80% non-condensing |
Prerequisites for working on Sartorius high-resolution balances, including experience and tools.
Warning regarding unsuitable measuring and test equipment.
Steps to access the balance operating menu and set a menu access code.
Guidelines for using calibrated weights for span testing and traceability.
Procedure to check balance reproducibility using test weights and calculating standard deviation.
Formula and method for calculating standard deviation from weighing results.
Procedure to test off-center loading tolerances using specified weights.
Procedure for checking internal span adjustment using calibrated weights.
Order of adjustments: reproducibility, off-center load, linearity, span.
Steps to prepare the balance for adjustment, including service prerequisites and BPI mode.
Procedure for coarse adjustment of off-center load using 3 points.
Procedure for fine adjustment of off-center load using 5 points.
Reference to the linearity check procedure on page 12.
Methods for external linearity adjustment using service programs.
Procedure for internal linearity adjustment using balance menu codes.
Specific procedure for external linearity adjustment on MC-balances.
Procedure for external span adjustment when internal adjustment weight is out of tolerance.
Procedure to overwrite internal linearity weights using balance menu codes.
External adjustment must be performed before overwriting internal adjustment weight.
Procedure to overwrite internal adjustment weights using balance menu codes.
Procedure for internal adjustment using balance menu codes.
Procedure for exchanging the display PCB module.
Procedure for exchanging the digital PCB, including data transfer.
Procedure for exchanging the analog PCB, including resistor transfer and data EEPROM update.
To Next Page