Sartorius SIWADCP - Individual ID codes (identifiers)

Signum 1-2-3
Operation
49
Individual ID codes
(identifiers)
Signum
®
3 only:
You can assign codes (such as
product name, batch number, etc.)
for identification of measured values
on printouts.
Characteristics
– Assign up to four ID codes.
– Assign both a name and a value to
each ID code.
– Displaying individual IDs: d key
– The name is left-justified and the value
is right-justified on the printout. If the
entire code is too long for one line,
additional lines are printed.
– Enter ID code names in Setup under:
setup:
prtprot: 7.4.
The name can have a max. of 20
characters. No more than 11 characters
are displayed during input; all 20
characters are printed.
– Enter up to 40 characters for the value
of the ID code. Press the d key to
activate the input mode.
– Individual characters of the ID can be
deleted using the c key.
– If both the name and value fields are
empty, no ID code is printed.
– In the Setup program, you can
configure when and whether ID
codes are printed (see Configuring
Printouts page 81).
Factory settings for the ID code names
ID1:
ID1
ID2:
ID2
ID3:
ID3
ID4:
ID4
Factory settings for the ID code values
No default values set.