Example with Signum 3:
Weigh with numerical input of the tare weight,
Print the result
e
1 Switch on the scale.
The automatic self-test runs.
When the weight readout
is shown, the scale is ready to
to operate and automatically
set to zero.
Press ( to reset the
unloaded weighing platform
to zero at any time.
250
2 Enter the known tare weight
via the keypad
(in this example, 250 g).
)
3 Save the tare weight.
4 Place the sample (in this
example, 2 kg) in its container
on the scale.
Read the result
L
5 Toggle the display from
net to gross weight values.
The display shows the gross
weight (in this example,
250 g for the container plus
2000 g for the sample).
L
6 Return to the previous display.
p
7 Print the results.
--------------------
G# + 2.250 kg
T + 0.000 kg
PT2 + 0.250 kg
N + 2.000 kg
--------------------
Operation
40
Example with Signum 1:
Tare the scale by placing a container on the weighing platform
e
1 Switch on the scale.
The automatic self-test runs.
When the weight readout
is shown, the scale is ready
to operate and automatically
set to zero. Press ( to reset
the un-loaded weighing
platform to zero at any time.
2 Place empty container on
the platform.
)
3 Tare the scale.
Note: If the automatic tare
function is active, you do not
need to press ) to tare the
scale; the tare weight is saved
automatically when you place
the container on the platform.
Wait until a zero value is
displayed together with the
NET symbol.
4 Place sample on the platform
Wait until the weight unit is
shown (stability symbol) and
read off the weight value.
To Next Page
Loading...
