Sartorius SIWRDCP - Calibration, Preload, and Geographical Data; Internal Calibration and Preload Settings; Geographical Data and Verification Notes

Preparation
§ Switch on the scale: Press e
§ While all segments are lit, press the ) key
§ Select the Setup menu: Press k repeatedly until
Setup is displayed
§ Open the Setup menu: Press the ) key
$ Select weighing platform 1, “
WP1”: Press the ) key, or
$ Select interface 1, “
COM1” or interface 2, “COM2” (depending n the interface used):
Press the k key
Select weighing platform 2, “
WP”: Press the ) key
Setup
wp-1
1
1.9. Calibration and Adjustment
1.9.1* Ext. calibration/adjustment; default weight
1.9.3 Ext. calibration/adjustment; weight can be
selected under menu item 1.18.1
1.9.4 Internal calibration/adjustment (models with
built-in motorized calibration weight only)
1.9.8 Set preload
1.9.9 Clear preload
1.9.10 No function when you press
J
1.10. Calibration/Adjustment Sequence
1.10.1 Calibration with automatic adjustment
1.10.2* Calibration with adjustment triggered manually
1.11. Zero-setting Range
1.11.1 1 percent/max. cap.
1.11.2* 2 percent/max.cap.
1.12. Initial Zero-setting Range
1.12.1* Factory setting (depends on model)
1.12.2 2 percent/max. cap.
1.12.3 5 percent/max.cap. (setting depends on model)
1.13. Tare/zero at Power On
1.13.1* On
1.13.2 Off, load previous tare value
1.13.3 Only zero at power on
1.15. Calibration Prompt
1.15.1* Off
1.15.2 Calibration prompt (W) flashes on the display
1.16. External Calibration
1)
1.16.1* Accessible
1.16.2
2)
Blocked
1.17. Calibration weight unit
1.17.1 Grams
1.17.2* Kilograms
1.17.4 Pounds
1)
1.18. Enter Calibration Weight
1.18.1 External user-defined weight
(enter value; e.g.: 10,000 g)
§ Save settings and exit operating menu:
( key (repeatedly)
1)
= Setting cannot be changed on verified models
2)
= Factory setting on verified models
* Factory setting
Operation
44