Example 1: “Breaking bulk” (Counting, Checkweighing and Totalizing)
Settings (changes in the factory settings required for this example):
Setup: Application 1: Counting (
count)
Setup: Application 2: Checkweighing (
check.wg)
Setup: Application 3: Totalizing: Value saved: Net + calculated (
3.23.3)
Setup: Application 3: Totalizing: Autosave: On (
3.16.2)
Setup: Application 3: Totalizing: Source of data: Application 2 (
3.22.2)
Setup: Printout,
PrtProt: 7.8. “Configuration list, total”; then select the menu line items of your choice
“Total printout: Print when
k pressed;” then select the menu line items of your choice (x.xx.x) (see “Configuration” for options)
e
1 Switch on the scale and configure as described above
c
2 Delete any data from previous operation
3 Place empty container on the platform
)
4 Tare the scale
Note: If the automatic tare function is enabled, you do not need to press the ) key to tare the scale;
the tare weight is saved automatically when you place the container on the platform
5 Place a number of parts in the container for the reference quantity
(in this example, 10 pcs)
O
6 Activate calculation of the reference sample weight
Examples of Application Combinations in Signum 3 ZOL
78
To Next Page
Loading...
