Press the TIME button again. The minutes display will begin to blink.
Press the ▲ or ▼ buttons until you reach the correct minutes.
Press the TIME button again. The day of the week will begin to blink.
Press the ▲ or ▼ buttons until you reach the correct day of the week.
Press the TIME button again. The display will now indicate the correct
time and day of the week.
3. Filter timer
a) When in configuration the selections are in months, each month selections
are equal to 30 days.
b) To review the remaining days press the
"F"
button.
c) To reset the filter days – press the
"F"
button (to enter the filter program)
and then hold the ▲ and ▼ buttons. This resets the timer and starts
To Next Page
Loading...
Need help?
General
