Planning your program
Note: The time of day clock MUST be set to the correct day and time in order
for the programmed times to be correct.
Look at the factory preprogrammed times and temperatures shown in the
Factory default program setting. If this program will suit your needs, simply
press the RUN button to begin running the factory preset program.
If you wish to change the preprogrammed time and temperature, follow these
steps:
Determine the time periods and temperatures for your program. You must
program four periods for each day. However, you may use the same heating
and cooling temperatures for consecutive time periods. You can choose
heating temperature, cooling temperature and start time independently. (for
To Next Page
Loading...
Need help?
General
